1.按住接收机小按钮不松开，然后上电，直到看到接收机红灯和绿灯都常亮，然后松开按钮。
2.遥控器调节到并选择bind选项（弹出选项可选ch1-8 telem off），此时遥控器将会不断的发出滴滴声。

  1. 此时可看到接收机绿灯仍然保持常亮，而红灯变为闪烁状态，表示配对完成。
    4.遥控器按exit键退出bind。接收机全部断电重启，重启后看到绿灯长亮（红灯熄灭）即可。



8 months later

How do I get into this menu?
Can find it in my x7...

    10 days later

    Short press on the "menu" button will call out this setup menu.
    Press page button to transverse setup pages.

      5 months later

      Hi, in the first step, I only see the red light is constant light, but the green light constant off. How can I solve it?

      Moreover, when I used another controller finished the second step, move to the third step, the red light of the receiver remains on, while the green light is constant off, meanwhile, the remote control will continue to drip. How can I solve it?
      Many thanks

        LukasLi

        In 1st step, you may need to hold that tiny 'Bind' button for bit longer time until the green LED light up. The button is really small, probably little bit difficult to access, so make sure you do have press on it, and then switch power on only after. Release it only after you see green LED on.

        If you fail the 1st step the paring would not succeed.

            Write a Reply...